Switching Between Local And Remote - YASKAWA FSDrive-MV1000 Instructions Manual

4.3 The Drive and Programming Modes

◆ Switching between LOCAL and REMOTE

When the drive is set to accept the Run command from the digital operator RUN key, this is referred to as LOCAL mode.
When the drive is set to accept the Run command from an external device (via the input terminals, serial
communications, etc.) this is referred to as REMOTE mode.
WARNING! Sudden Movement Hazard. The drive may start unexpectedly if the Run command is already applied when switching
from LOCAL mode to REMOTE mode when b1-07 = 1, resulting in death or serious injury. Be sure all personnel are
clear of rotating machinery.
The operation can be switched between LOCAL and REMOTE either by using the
Note: 1. After selecting LOCAL, the LO/RE light will remain lit.
2. The drive will not allow the user to switch between LOCAL and REMOTE during run.
Using the LO/RE Key on the Digital Operator
■
1 Turn on the power to the drive. The initial display appears.
Press . The LO/RE light will light up.
2
To set the drive for REMOTE operation, press the
on.
Using Sequence Input Terminals 1 to 16 to Switch between
■
The user can also switch between LOCAL and REMOTE modes using one of the sequence input terminals H1-01 to H1-
16 (set the corresponding parameter H1-
The following section describes the procedure for configuring the sequence input terminals.
Note: Setting H1- to 1 disables the LO/RE key on the digital operator.
88
Operating Procedure
key again. The LO/RE light will turn
LO
RE
to "1").
key on the digital operator or a digital input.
LOCAL and REMOTE
YASKAWA ELECTRIC EZZ010928 FSDrive-MV1000 Instructions
LCD Display
- MODE - DRV Rdy
FREF(OPR)
U1-01= 0.00Hz
U1-02= 0.00Hz
LSEQ
U1-03= 0.0A
LREF
JOG FWD FWD/REV
DIGITAL OPERATOR JVOP-180 ALM
- MODE - DRV Rdy
OPR
U1-01= 0.00Hz
U1-02= 0.00Hz LSEQ
U1-03= 0.00A LREF
JOG FWD FWD/REV
F1 F2
LO
ESC
RE
RESET ENTER
RUN STOP
Off Lit