Setup Group Parameters - YASKAWA FSDrive-MV1000 Instructions Manual

◆ Setup Group Parameters

Setup Group (STUP)
■
Parameters used in this drive are categorized into A to U. In order to simplify the drive's setup, only the frequently used
parameters are selected into the setup mode.
1.
Display the "Setup Group" screen first. Press the
2.
Select a parameter, and change the setting.
Group. If a parameter to set is not found in the Setup Group, use the "Parameter Setting Mode" screen.
Note: 1. When the parameter "A1-02" (Control Method Selection) is changed, the setting values of some parameters are changed
automatically.
2. This manual explains also the parameters that are not displayed in the setup mode. Use the "Par" menu in the program mode when
setting a parameter that is not displayed in the setup mode.
No.
A1-02 Control Method Selection
A1-06 Application Preset
b1-01 Frequency Reference Selection 1
b1-02 Run Command Selection 1
b1-03 Stopping Method Selection
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
d1-01 Frequency Reference 1
d1-02 Frequency Reference 2
d1-03 Frequency Reference 3
d1-04 Frequency Reference 4
d1-17 Jog Frequency Reference
E1-01 Input Voltage Setting
E1-04 Maximum Output Frequency
YASKAWA ELECTRIC EZZ010928 FSDrive-MV1000 Instructions
Table 4.5
Table 4.5 Setup Group Parameters
Name
4.3 The Drive and Programming Modes
or key until the "Setup Group" screen is displayed.
shows the parameters that can be used in the Setup
No.
E1-05 Maximum Voltage
E1-06 Base Frequency
E1-09 Minimum Output Frequency
E1-13 Base Voltage
E2-01 Motor Rated Current
E2-04 Number of Motor Poles
E2-11 Motor Rated Power
H4-02 Analog Output 1 Gain
H4-12 Analog Output 2 Gain
H4-22 Analog Output 3 Gain
H4-32 Analog Output 4 Gain
L1-01 Motor Overload Protection Selection
L3-04 Stall Prevention Selection during Deceleration
Name
4
89