Konica Minolta bizhub 1250 User Manual page 95

4
7
Specify 2-side slitting width.
Select [(1)] for "Slitting", and press the keypad, [,], or [+] to enter the slitting amount for the head. Like-
wise, press [(2)] and enter the slitting amount for the foot.
[Offset against Cover] will not function, even if specified.
% The difference of specified slitting between the head and the foot must not exceed 10.0 mm.
8
Press [OK].
The Multi Tri-Fold Setting Screen will be restored.
9
Press [OK].
% To restore the previous setting, press [Cancel].
% To disable the function while keeping the current setting, press [Function OFF].
The Output Setting Screen will be restored.
% [Multi 3-Fold] and [2-Side Slit] are highlighted. 2-side slitting settings can be changed by pressing
[2-Side Slit].
10
Press [OK].
% To restore the previous setting, press [Cancel].
% To disable the function while keeping the current setting, press [Function OFF].
The Output Setting Screen will be restored.
% [Multi 3-Fold] and [Crease] are highlighted. [Crease] has now become unavailable, and the crease
settings cannot be changed.
11
Press [OK] on the Output Setting Screen to return to the Copy Screen.
An icon representing specified output mode will be displayed under [Output Setting] on the Copy
Screen.
12
Select additional copy conditions, as desired.
% In bizhub PRESS 1250/1250P/1052, you can load sheets onto a tray, and use [Paper Presetting] to
change the paper setting temporarily. See the User's Guide supplied with this machine for details
on [Paper Presetting].
13
Enter the desired print quantity from the control panel keypad.
% Up to 40 sets of 1-sheet-tri-folded paper (for 22 lb Bond (80 g/m
fold tray.
14
Press Start on the control panel.
4-58
Performing 2-Side Slitting on Multi Tri-Folded Paper
2
) paper) can be load onto the tri-
Saddle Stitcher SD-513
4.10