Konica Minolta bizhub 1250 User Manual page 154

5.4 [Saddle Stitcher Adjustment] - [Staple Pitch Adjustment]
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Display the Staple Pitch Adjustment Screen of 4 Position Staple (Front 2 positions).
% In bizhub PRESS 1250/1250P/1052, press [02 Finisher Adjustment], [08 Saddle Stitcher Adjust-
ment], [03 Staple Pitch Adjustment], and [02 4 Position Staple (Front 2)] in sequence.
% In bizhub PRESS C1070/C1070P/C1060/C71hc, press [04 Finisher Adjustment], [04 Saddle
Stitcher Adjustment], [03 Staple Pitch Adjustment], and [02 4 Position Staple (Front 2)] in sequence.
% In bizhub PRESS C1100/C1085, press [03 Finisher Adjustment], [04 Saddle Stitcher Adjustment],
[03 Staple Pitch Adjustment], and [02 4 Position Staple (Front 2)] in sequence.
3
Select the size to be adjusted.
4
Press [Print Mode].
5
Load the paper size selected in step 3 into the tray, then select that tray key.
6
Press Start on the control panel. A sample pattern will be output.
7
Measure the pitch of the front 2 positions of 4 Position Staple relative to paper size.
8
Exit the print mode to return to the Staple Pitch Adjustment Screen.
% In bizhub PRESS 1250/1250P/1052, press [Close].
% In bizhub PRESS C1070/C1070P/C1060/C71hc or bizhub PRESS C1100/C1085, press [Exit
PrintMode].
9
If adjustment is required, use the touch panel keypad or control panel keypad to enter the setting data.
% Adjustable range: -10 (To shorten) to 10 (To lengthen) (1 step = 1.0 mm)
% Use [+<->-] to specify the value to be positive or negative.
% Available range of the adjustment may vary depending on paper sizes.
10
Press [Set] to change the current data.
11
Repeat the steps from 4 to 10 until the desired result is obtained.
12
Press [Return] to restore the Staple Pitch Adjustment Menu Screen.
Saddle Stitcher SD-513
5
5-25