Konica Minolta bizhub 1250 User Manual page 172

5.12 [Saddle Stitcher Adjustment] - [Crease Position Adjustment]
3
Select the size to be adjusted using [+] or [,] to scroll.
4
Press [Print Mode].
5
Load the paper size selected in step 3 into the tray, then select that tray key.
6
Press Start on the control panel. A sample pattern will be output.
7
Check the misalignment (a) between the fold and crease of the output sheet.
Allowance: a = within ^ 1 mm
[1] Fold
8
Exit the print mode to return to the Half-Fold Crease Position Adjustment Screen.
% In bizhub PRESS 1250/1250P/1052, press [Close].
% In bizhub PRESS C1070/C1070P/C1060/C71hc or bizhub PRESS C1100/C1085, press [Exit
PrintMode].
9
If adjustment is required, use the touch panel keypad or control panel keypad to enter the setting data.
% Adjustable range: -20 (To shorten) to +20 (To lengthen) (1 step = 0.1 mm)
% Use [+<->-] to specify the value to be positive or negative.
% Adjust the distance between the cover edge of the output top face and the crease.
10
Press [Set] to change the current data.
11
Repeat the steps from 4 to 10 until the desired result is obtained.
12
Press [Return] to restore the Crease Position Adjustment Menu Screen.
Saddle Stitcher SD-513
[2] Edge of crease
5
5-43