Adding Fold Lines (Creases) For Fold & Stapled/Multi Half-Folded Cover; Functional Overview - Konica Minolta bizhub 1250 User Manual

4
4.6 Adding Fold Lines (Creases) for Fold & Stapled/Multi Half-Folded
Cover
4.6.1

Functional Overview

When the machine uses Creaser Unit CR-101 equipped in Saddle Stitcher SD-513, and when creating cov-
er with fold & staple or multi half-fold, one piece of crease can be added to cover as a fold line.
Setting item
[Fold&Staple]
Fold & Staple Set-
ting Screen,
[Crease] to be set to
[ON]
[Multi Half]
Multi Half-Fold Set-
ting Screen,
[Crease] to be set to
[ON]
NOTICE
Crease cannot be added on body when Fold & Staple or Multi Half Fold mode is selected.
The crease position is fixed at the center.
The crease side selection is not available.
NOTICE
The multi half-folded and stapled sets will be delivered onto the bundle exit tray. Set up the bundle exit tray
extension, and follow the preparation process before opening the stopper. Failing to carry out the prepara-
tion may lead to output sheets falling off the bundle exit tray. It could also cause the sensor to fail to detect
the output full condition.
4-36
Adding Fold Lines (Creases) for Fold & Stapled/Multi Half-Folded Cover
Details
Using Booklet as an ap-
plication function in
combination, when se-
lecting [Cover With Copy
Sheet], or [Cover With
Blank Sheet], adds a sin-
gle crease on cover only
and fold & staple with
body. Fore-edge trim-
ming can be combined.
Using Booklet as an ap-
plication function in
combination, when se-
lecting [Cover With Copy
Sheet], or [Cover With
Blank Sheet], adds a sin-
gle crease on cover only
and multi half-hold with
body. Fore-edge trim-
ming can be combined.
Illustration
4.6
Saddle Stitcher SD-513