Traffic Metering Logs; Unicast, Multicast, And Broadcast Logs - NETGEAR UTM5 Reference Manual

ProSecure Unified Threat Management (UTM) Appliance
• PPP Authentication logs
Table 166. System logs: WAN status, PPP authentication
Message 1
Message 2
Message 3
Message 4
Explanation
Recommended Action If authentication fails, verify the correct login name and password, and then enter

Traffic Metering Logs

This section describes logs that are generated when the traffic meter has reached a limit.
Table 167. System logs: traffic metering
Message
Explanation
Recommended Action

Unicast, Multicast, and Broadcast Logs

This section describes logs that are generated when the UTM processes unicast packets.
Table 168. System logs: unicast
Message
Explanation
Recommended Action
Nov 29 11:29:26 [UTM] [pppd] Starting link
Nov 29 11:29:29 [UTM] [pppd] Remote message: Login incorrect
Nov 29 11:29:29 [UTM] [pppd] PAP authentication failed
Nov 29 11:29:29 [UTM] [pppd] Connection terminated. WAN2(DOWN)_
Message 1: The PPPoE connection process starts.
Message 2: The PPPoE server indicates that the login is incorrect.
Message 3: The PPP authentication fails because of incorrect login.
Message 4: The PPP connection terminates.
the correct information.
Jan 23 19:03:44 [TRAFFIC_METER] TRAFFIC_METER: Monthly Limit of 10 MB
has reached for WAN1._
Logs that are generated when the traffic limit for WAN1 interface that was set at 10
MB has been reached. Depending on the setting that is configured in the When
Limit is reached section on the WAN1 Traffic Meter screen (see
Traffic Meter on page 434), all the incoming and outgoing traffic might be stopped.
Note: For WAN2 interface, see the settings on the WAN2 Traffic Meter screen.
To start the traffic, restart the traffic counter in the Traffic Counter section on the
WAN1 Traffic Meter screen.
Note: For WAN2 interface, see the settings on the WAN2 Traffic Meter screen.
Nov 24 11:52:55 [UTM] [kernel] UCAST IN=SELF OUT=WAN SRC=192.168.10.1
DST=192.168.10.10 PROTO=UDP SPT=800 DPT=2049
• This unicast packet is sent to the device from the WAN network.
• For other settings, see
None.
System Logs and Error Messages
604
Table 154 on page 597.
Enable the WAN