NETGEAR UTM5 Reference Manual page 72

ProSecure Unified Threat Management (UTM) Appliance
6. If your connection is PPTP or PPPoE, your ISP requires an initial login. Enter the settings as
explained in the following table:
Table 14. PPTP and PPPoE settings
Setting Description
Austria (PPTP) If your ISP is Austria Telecom or any other ISP that uses PPTP for login, select this radio
button, and enter the following settings:
Account Name
Domain Name
Idle Timeout
My IP Address
Server IP
Address
Other (PPPoE) If you have installed login software, then your connection type is PPPoE. Select this radio
button, and enter the following settings:
Account Name
Domain Name
Idle Timeout
The account name is also known as the host name or system name.
Enter the account name for the PPTP connection (usually your email ID
assigned by your ISP). Some ISPs require you to enter your full email
address here.
Your domain name or workgroup name assigned by your ISP, or your
ISP's domain name. You can leave this field blank.
Select the Keep Connected radio button to keep the connection always
on. To log out after the connection is idle for a period of time, select the
Idle Timeout radio button and, in the time-out field, enter the number of
minutes to wait before disconnecting. This is useful if your ISP charges
you based on the period that you have logged in.
The IP address assigned by the ISP to make the connection with the
ISP server.
The IP address of the PPTP server.
The account name for the PPPoE connection.
The name of your ISP's domain or your domain name if your ISP has
you assigned one. You can leave this field blank.
Select the Keep Connected radio button to keep the connection always
on. To log out after the connection is idle for a period of time, select the
Idle Timeout radio button and, in the time-out field, enter the number of
minutes to wait before disconnecting. This is useful if your ISP charges
you based on the period that you have logged in.
Note: When you use a PPPoE connection and select the Idle Timeout
radio button, you cannot configure load balancing (see
Balancing (Multiple WAN Port Models)
balancing on a PPPoE connection, select the Keep Connected radio
button. When you have configured load balancing, the Idle Timeout
radio button and time-out field are masked out.
Manually Configuring Internet and WAN Settings
72
Configure Load
on page 80). To use load