NETGEAR UTM5 Reference Manual page 135


To delete or disable one or more rules:
1. Select the check box to the left of each rule that you want to delete or disable, or click
the Select All table button to select all rules.
2. Click one of the following table buttons:
• Disable. Disables the selected rule or rules. The ! status icon changes from a green
circle to a gray circle, indicating that the selected rule is or rules are disabled. (By
default, when a rule is added to the table, it is automatically enabled.)
• Delete. Deletes the selected rule or rules.
DMZ WAN Outbound Service Rules
You can change the default outbound policy or define rules that specify exceptions to the
default outbound policy. By adding custom rules, you can block or allow access based on the
service or application, source or destination IP addresses, and time of day. An outbound rule
can block or allow traffic between the DMZ and any external WAN IP address according to
the schedule created in the Schedule screen.

To create a new outbound DMZ WAN service rule:
1. In the DMZ WAN Rules screen, click the Add table button under the Outbound Services
table. The Add DMZ WAN Outbound Service screen displays:
Figure 69.
2. Enter the settings as explained in
3. Click Apply. The new rule is now added to the Outbound Services table. The rule is
automatically enabled.
ProSecure Unified Threat Management (UTM) Appliance
Table 27
Firewall Protection
on page 123.
135