NETGEAR UTM5 Reference Manual page 48

ProSecure Unified Threat Management (UTM) Appliance
Enter the settings as explained in the following table, and then click Next to go the following
screen.
Note: Instead of manually entering the settings, you can also click the
Auto Detect action button at the bottom of the screen. The
autodetect process probes the WAN port for a range of connection
methods and suggests one that your ISP is most likely to support.
Table 5. Setup Wizard Step 2: WAN Settings screen settings
Setting Description
ISP Login
Does your Internet If you need to enter login information every time you connect to the Internet through
connection require a your ISP, select the Yes radio button. Otherwise, select the No radio button, which is
login? the default setting, and skip the ISP Type section. If you select the Yes radio button,
enter the following settings.
Login
Password
ISP Type
What type of ISP If your connection is PPPoE or PPTP, then you need to log in. Select the Yes radio
connection do you button. Based on the connection that you select, the text fields that require data entry
use? are highlighted. If your ISP has not assigned any login information, then select the No
radio button and skip this section. If you select the Yes radio button, enter the following
settings.
Austria (PPTP) If your ISP is Austria Telecom or any other ISP that uses PPTP for login, select this
radio button and enter the following settings:
Account Name
Domain Name
Idle Timeout
My IP Address
Server IP Address
Using the Setup Wizard to Provision the UTM in Your Network
The login name that your ISP has assigned to you.
The password that your ISP has assigned to you.
The account name is also known as the host name or system
name. Enter the valid account name for the PPTP connection
(usually your email ID assigned by your ISP). Some ISPs
require you to enter your full email address here.
Your domain name or workgroup name assigned by your ISP,
or your ISP's domain name. You can leave this field blank.
Select the Keep Connected radio button to keep the
connection always on. To log out after the connection is idle
for a period of time, select the Idle Timeout radio button and,
in the time-out field, enter the number of minutes to wait
before disconnecting. This is useful if your ISP charges you
based on the period that you have logged in.
The IP address assigned by the ISP to make the connection
with the ISP server.
The IP address of the PPTP server.
48