Configuring An Intra-Domain Multi-Segment Pw - HP MSR2000 Configuration Manual

# Display L2VPN PW information on PE 2. The output shows that a remote CCC connection has been
established.
[PE2] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: ccc
Peer
10.2.2.2
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)

Configuring an intra-domain multi-segment PW

Network requirements
As shown in
between PE 1 and P, and an MPLS TE tunnel between P and PE 2.
Configure a multi-segment PW between PE 1 and PE 2, so CE 1 and CE 2 can communicate over the
backbone. The multi-segment PW includes an LDP PW between PE 1 and P, and a static PW between P
and PE 2. The two PWs are concatenated on P.
Figure 104 Network diagram
Table 40 Interface and IP address assignment
Device
CE 1
PE 1
CE 2
Configuration procedure
1. Configure CE 1.
<CE1> system-view
[CE1] interface gigabitethernet 2/1/1
PW ID/Rmt Site
-
Figure 104, there is no public tunnel between PE 1 and PE 2. There is an MPLS TE tunnel
Interface IP address
GE2/1/1 100.1.1.1/24
Loop0 192.2.2.2/32
GE2/1/2 23.1.1.1/24
GE2/1/1 100.1.1.2/24
In/Out Label Proto
202/102 Static
Device
P
PE 2
412
Flag Link ID State
M 0 Up
Interface IP address
Loop0 192.4.4.4/32
GE2/1/1 23.1.1.2/24
GE2/1/2 26.2.2.2/24
Loop0 192.3.3.3/32
GE2/1/2 26.2.2.1/24