HP MSR2000 Configuration Manual page 448

Figure 107 Network diagram
Configuration procedure
1. Configure IP addresses and masks for interfaces as shown in
2. Create MPLS TE tunnels on Router A:
# Create two MPLS TE tunnels (Tunnel 1 and Tunnel 2) to Router D. For more information, see
"Configuring MPLS TE."
# Execute the display mpls tunnel all command on Router A to display information about the two
MPLS TE tunnels.
<RouterA> display mpls tunnel all
Destination
4.4.4.4
4.4.4.4
# Execute the display interface tunnel command on Router A. The output shows that the tunnel
interface is up. This example uses Tunnel 1.
<RouterA> display interface tunnel 1
Tunnel1
Current state: UP
Line protocol state: UP
Description: Tunnel1 Interface
Bandwidth: 64kbps
Maximum Transmit Unit: 1496
Internet Address is 10.1.10.1/24 Primary
Tunnel source unknown, destination 4.4.4.4
Tunnel TTL 255
Tunnel protocol/transport CR_LSP
Type Tunnel/NHLFE
CRLSP Tunnel1
CRLSP Tunnel2
439
Figure 107. (Details not shown.)
VPN Instance
-
-