Configuring Routing Between Pes; Configuring Bgp Vpnv4 Route Control - HP MSR2000 Configuration Manual

Step
5. Enable IPv4 unicast route
exchange with the specified
peer or peer group.
6. (Optional.) Configure route
redistribution.

Configuring routing between PEs

Step
1. Enter system view.
2. Enter BGP view.
3. Configure the remote PE as a
BGP peer.
4. Specify the source interface for
route updates.
5. Create
address family and enter its
view.
6. Enable BGP VPNv4 route
exchange with the specified
peer.

Configuring BGP VPNv4 route control

BGP VPNv4 route control is configured similarly with BGP route control, except that it is configured in
BGP VPNv4 address family view. For detailed information about BGP route control, see Layer 3—IP
Routing Configuration Guide.
To configure BGP VPNv4 route control:
Step
1. Enter system view.
2. Enter BGP view.
3. Enter BGP VPNv4 address
family view.
4. Configure
advertised routes.
Command
peer { group-name | ip-address }
enable
import-route protocol
[ { process-id | all-processes }
[ allow-direct | med med-value |
route-policy route-policy-name ]
* ]
Command
system-view
bgp as-number
peer { group-name | ip-address }
as-number as-number
peer { group-name | ip-address }
connect-interface interface-type
interface-number
the BGP VPNv4
address-family vpnv4
peer { group-name | ip-address }
enable
Command
system-view
bgp as-number
address-family vpnv4
filter-policy { acl-number |
filtering of
prefix-list prefix-list-name } export
[ protocol process-id ]
Remarks
By default, BGP does not
exchange IPv4 unicast routes
with any peer.
A CE must redistribute its routes
to the PE so the PE can advertise
them to the peer CE.
196
Remarks
N/A
N/A
By default, no BGP peer is created.
By default, BGP uses the egress
interface of the optimal route
destined for the peer as the source
interface.
By default, the BGP VPNv4
address family is not created.
By default, BGP does not exchange
BGP VPNv4 routes with any peer.
Remarks
N/A
N/A
N/A
Optional.
By default, BGP does not filter
advertised routes.