HP MSR2000 Configuration Manual page 239

[PE1-tunnel-policy-gre1] select-seq gre load-balance-number 1
[PE1-tunnel-policy-gre1] quit
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 100:1
[PE1-vpn-instance-vpn1] vpn-target 100:1 both
[PE1-vpn-instance-vpn1] tnl-policy gre1
[PE1-vpn-instance-vpn1] quit
[PE1] interface gigabitethernet 2/1/1
[PE1-GigabitEthernet2/1/1] ip binding vpn-instance vpn1
[PE1-GigabitEthernet2/1/1] ip address 10.1.1.2 24
[PE1-GigabitEthernet2/1/1] quit
# Configure PE 2.
[PE2] tunnel-policy gre1
[PE2-tunnel-policy-gre1] select-seq gre load-balance-number 1
[PE2-tunnel-policy-gre1] quit
[PE2] ip vpn-instance vpn1
[PE2-vpn-instance-vpn1] route-distinguisher 100:2
[PE2-vpn-instance-vpn1] vpn-target 100:1 both
[PE2-vpn-instance-vpn1] tnl-policy gre1
[PE2-vpn-instance-vpn1] quit
[PE2] interface gigabitethernet 2/1/1
[PE2-GigabitEthernet2/1/1] ip binding vpn-instance vpn1
[PE2-GigabitEthernet2/1/1] ip address 10.2.1.2 24
[PE2-GigabitEthernet2/1/1] quit
# Configure CE 1.
<CE1> system-view
[CE1] interface gigabitethernet 2/1/1
[CE1-GigabitEthernet2/1/1] ip address 10.1.1.1 24
[CE1-GigabitEthernet2/1/1] quit
# Configure CE 2.
<CE2> system-view
[CE2] interface gigabitethernet 2/1/1
[CE2-GigabitEthernet2/1/1] ip address 10.2.1.1 24
[CE2-GigabitEthernet2/1/1] quit
# Execute the display ip vpn-instance command on the PEs to display the configuration of the VPN
instance, for example, on PE 1.
[PE1] display ip vpn-instance
Total VPN-Instances configured : 1
VPN-Instance Name
vpn1
# Use the ping command on the PEs to verify that the PEs can ping their attached CEs, for example,
on PE 1.
[PE1] ping -vpn-instance vpn1 10.1.1.1
Ping 10.1.1.1 (10.1.1.1): 56 data bytes, press CTRL_C to break
56 bytes from 10.1.1.1: icmp_seq=0 ttl=255 time=1.000 ms
56 bytes from 10.1.1.1: icmp_seq=1 ttl=255 time=0.000 ms
56 bytes from 10.1.1.1: icmp_seq=2 ttl=255 time=0.000 ms
RD
100:1
230
Create time
2012/02/13 15:59:50