Configuring An Ldp Pw; Configuring A Bgp Pw - HP MSR2000 Configuration Manual

Configuring an LDP PW

Before you configure an LDP PW, enable global and interface MPLS LDP on the PE. For information about
MPLS LDP configuration, see "Configuring LDP."
To configure an LDP PW:
Step
1. Enter system view.
2. Enter cross-connect group
view.
3. Enter cross-connect view.
4. Configure an LDP PW and
enter cross-connect PW view.

Configuring a BGP PW

To configure a BGP PW, perform the following configurations on PEs:
Configure BGP to advertise MPLS L2VPN label block information.
•
Create a BGP PW.
•
Configuring BGP to advertise MPLS L2VPN label block information
Step
1. Enter system view.
2. Enable BGP and enter BGP view.
3. Configure the remote PE as a
BGP peer.
4. Create a BGP L2VPN address
family and enter BGP L2VPN
address family view.
5. Enable BGP to exchange BGP
L2VPN information with the
specified peer or peer group.
6. Enable BGP to exchange label
block information with the
specified peer or peer group.
Command
system-view
xconnect-group group-name
connection connection-name
peer ip-address pw-id pw-id
[ pw-class class-name |
tunnel-policy tunnel-policy-name ] *
Command
system-view
bgp as-number
peer { group-name | ip-address }
as-number as-number
address-family l2vpn
peer { group-name | ip-address }
enable
peer { group-name | ip-address }
signaling [ non-standard ]
384
Remarks
N/A
N/A
N/A
By default, no LDP PW is
configured.
If the specified peer PE is not
directly connected, the local PE
automatically sends a targeted
hello to create an LDP session to the
peer PE and then exchanges the
PW ID FEC and PW label mapping
with the peer.
Remarks
N/A
By default, BGP is not
enabled.
By default, no BGP peer is
configured.
By default, no BGP L2VPN
address family is created.
By default, BGP cannot
exchange BGP L2VPN
information with any peer or
peer group.
By default, BGP can
exchange label block
information with a BGP
L2VPN peer or peer group by
using RFC 4761
MP_REACH_NLRI.