HP MSR2000 Configuration Manual page 129

2.2.2.2/5/31857
3.2.1.2
3.1.1.2
# Shut down the protected interface GigabitEthernet 2/1/2 on the PLR (Router B).
[RouterB] interface gigabitethernet 2/1/2
[RouterB-GigabitEthernet2/1/2] shutdown
[RouterB-GigabitEthernet2/1/2] quit
# Execute the display interface tunnel 4 command on Router A to display information about the primary
CRLSP. The output shows that the tunnel interface is still up. (Details not shown.)
# Execute the display mpls te tunnel-interface command on Router A to display the detailed information
of the tunnel interface.
[RouterA] display mpls te tunnel-interface
Tunnel Name
Tunnel State
Tunnel Attributes
LSP ID
Admin State
Ingress LSR ID
Signaling
Resv Style
Tunnel mode
Reverse-LSP name
Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
Backup Explicit Path : -
Metric Type
Record Route
FRR Flag
Backup Bandwidth Flag: Disabled
Backup Bandwidth
Bypass Tunnel
Route Pinning
Retry Limit
Reoptimization
Backup Type
Auto Bandwidth
Min Bandwidth
Collected Bandwidth
NOTE:
If you execute the display mpls te tunnel-interface command immediately after an FRR, you can see two
CRLSPs in up state. This is because FRR uses the make-before-break mechanism to set up a new LSP, and
the old LSP is deleted after the new one has been established for a while.
RSVP -/3
Local -/-
Local -/-
: Tunnel 4
: Up (Main CRLSP up, Shared-resource CRLSP being set up)
:
: 18753 Tunnel ID
: Normal
: 1.1.1.1 Egress LSR ID
: RSVP-TE Static CRLSP Name
: SE
: -
: -
: - Reverse-LSP Tunnel ID: -
: CT0 Tunnel Bandwidth
: 0 kbps
: 7 Holding Priority
: 0/0
: pri-path
: TE
: Enabled Record Label
: Enabled Bandwidth Protection : Disabled
Backup Bandwidth Type: -
: -
: No Auto Created
: Disabled
: 10 Retry Interval
: Disabled Reoptimization Freq
: None Backup LSP ID
: Disabled Auto Bandwidth Freq
: - Max Bandwidth
: -
120
GE2/1/2
POS2/2/0
GE2/1/2
: 4
: 3.3.3.3
: -
: 0 kbps
: 7
: Enabled
: No
: 2 sec
: -
: -
: -
: -