HP MSR2000 Configuration Manual page 139

Destination/Mask
1.1.1.9/32
2.2.2.9/32
3.3.3.9/32
4.4.4.9/32
10.1.1.0/24
10.1.1.1/32
20.1.1.0/24
30.1.1.0/24
127.0.0.0/8
127.0.0.1/32
Configure an LSR ID, enable MPLS, MPLS TE, and RSVP-TE, and configure the DS-TE mode as IETF :
3.
# Configure Router A.
[RouterA] mpls lsr-id 1.1.1.9
[RouterA] mpls te
[RouterA-te] ds-te mode ietf
[RouterA-te] quit
[RouterA] rsvp
[RouterA-rsvp] quit
[RouterA] interface gigabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] mpls enable
[RouterA-GigabitEthernet2/1/1] mpls te enable
[RouterA-GigabitEthernet2/1/1] rsvp enable
[RouterA-GigabitEthernet2/1/1] quit
# Configure Router B.
[RouterB] mpls lsr-id 2.2.2.9
[RouterB] mpls te
[RouterB-te] ds-te mode ietf
[RouterB-te] quit
[RouterB] rsvp
[RouterB-rsvp] quit
[RouterB] interface gigabitethernet 2/1/1
[RouterB-GigabitEthernet2/1/1] mpls enable
[RouterB-GigabitEthernet2/1/1] mpls te enable
[RouterB-GigabitEthernet2/1/1] rsvp enable
[RouterB-GigabitEthernet2/1/1] quit
[RouterB] interface pos 2/2/0
[RouterB-POS2/2/0] mpls enable
[RouterB-POS2/2/0] mpls te enable
[RouterB-POS2/2/0] rsvp enable
[RouterB-POS2/2/0] quit
# Configure Router C.
[RouterC] mpls lsr-id 3.3.3.9
[RouterC] mpls te
[RouterC-te] ds-te mode ietf
[RouterC-te] quit
[RouterC] rsvp
[RouterC-rsvp] quit
Proto Pre Cost
Direct 0 0
ISIS 15 10
ISIS 15 20
ISIS 15 30
Direct 0 0
Direct 0 0
ISIS 15 20
ISIS 15 30
Direct 0 0
Direct 0 0
130
NextHop Interface
127.0.0.1 InLoop0
10.1.1.2 GE2/1/1
10.1.1.2 GE2/1/1
10.1.1.2 GE2/1/1
10.1.1.1 GE2/1/1
127.0.0.1 InLoop0
10.1.1.2 GE2/1/1
10.1.1.2 GE2/1/1
127.0.0.1 InLoop0
127.0.0.1 InLoop0