HP MSR2000 Configuration Manual page 361

[PE1-isis-1] quit
[PE1] interface loopback 0
[PE1-LoopBack0] isis enable 1
[PE1-LoopBack0] quit
[PE1] interface pos 2/1/1
[PE1-Pos2/1/1] ip address 30.1.1.1 24
[PE1-Pos2/1/1] isis enable 1
[PE1-Pos2/1/1] mpls enable
[PE1-Pos2/1/1] mpls ldp enable
[PE1-Pos2/1/1] mpls ldp transport-address interface
[PE1-Pos2/1/1] quit
[PE1] bgp 100
[PE1-bgp] peer 4.4.4.9 as-number 100
[PE1-bgp] peer 4.4.4.9 connect-interface loopback 0
[PE1-bgp] address-family vpnv4
[PE1-bgp-vpnv4] peer 4.4.4.9 enable
[PE1-bgp-vpnv4] quit
[PE1-bgp] quit
# Configure PE 2 in the same way that PE 1 is configured. (Details not shown.)
# On PE 1, verify that the LDP session has been established.
[PE1] display mpls ldp peer
Total number of peers: 1
Peer LDP ID
4.4.4.9:0
# On PE 1, verify that the BGP peer relationship in Established state has been established.
[PE1] display bgp peer vpnv4
BGP local router ID: 3.3.3.9
Local AS number: 100
Total number of peers: 1
Peer
4.4.4.9
# On PE 1, verify that the IS-IS neighbor relationship has been established.
[PE1] display isis peer
System Id: 0000.0000.0005
Interface: POS2/1/1
State: Up HoldTime:
System Id: 0000.0000.0005
Interface: POS2/1/1
State: Up HoldTime:
State LAM
Operational DU
AS MsgRcvd
100 3
Peer information for ISIS(1)
----------------------------
Circuit Id: 0000.0000.0005.02
8s Type: L1(L1L2)
Circuit Id: 0000.0000.0005.02
8s Type: L2(L1L2)
352
Role GR MD5
Active Off Off
Peers in established state: 1
MsgSent OutQ PrefRcv Up/Down
6 0
PRI: 64
PRI: 64
KA Sent/Rcvd
8/8
State
0 00:00:32 Established