Configuring The Rate Limit; Configuring The Rate Limit For An Interface; Configuring The Rate Limit For A Pw - HP FlexNetwork MSR Series Configuration Manuals

Step
3. Configure
ACL-based GTS on
the interface.
Configuring GTS for all traffic
Step
1. Enter system view.
2. Enter interface view.
3. Configure GTS on
the interface.

Configuring the rate limit

Configuring the rate limit for an interface

The rate limit for an interface specifies the maximum rate of outgoing packets on the interface.
To configure the rate limit for an interface:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the rate limit
for the interface.

Configuring the rate limit for a PW

The rate limit for a PW specifies the maximum rate of outgoing packets on the PW. For information
about PWs, see MPLS Configuration Guide.
Command
qos gts acl [ ipv6 ] acl-number cir
committed-information-rate
committed-burst-size
excess-burst-size ] ] [ queue-length
queue-length ]
qos gts acl [ ipv6 ] acl-number cir
committed-information-rate
committed-burst-size
peak-information-rate
excess-burst-size ] [
queue-length ]
Command
system-view
interface
interface-number
qos gts
committed-information-rate
committed-burst-size
excess-burst-size ] ] [ queue-length
queue-length ]
qos gts
committed-information-rate
committed-burst-size
peak-information-rate
excess-burst-size ] [
queue-length ]
Command
system-view
interface
interface-number
qos lr outbound
committed-information-rate
committed-burst-size
excess-burst-size ] ]
53
[ cbs
[ ebs
By default, GTS is not configured
on an interface.
[ cbs
pir
]
[ ebs
queue-length
Remarks
N/A
interface-type
N/A
any cir
[ cbs
ebs
[
By default, GTS is not configured
any cir
on an interface.
[ cbs
] pir
[ ebs
queue-length
Remarks
N/A
interface-type
N/A
cir
[ cbs By default,
[ ebs configured on an interface.
Remarks
no rate limit is