HP MSR2000 Configuration Manual page 379

3. Configure BGP SoO attribute:
# On PE 1, configure the SoO attribute as 1:100 for CE 1.
<PE1> system-view
[PE1] bgp 100
[PE1-bgp] ip vpn-instance vpn1
[PE1-bgp-vpn1] address-family ipv6
[PE1-bgp-ipv6-vpn1] peer 10:1::1 soo 1:100
# On PE 2, configure the SoO attribute as 1:100 for CE 2.
[PE2] bgp 100
[PE2-bgp] ip vpn-instance vpn1
[PE2-bgp-vpn1] address-family ipv6
[PE2-bgp-ipv6-vpn1] peer 10:2::1 soo 1:100
Verifying the configuration
# PE 2 does not advertise routes received from CE 1 to CE 2 because the same SoO attribute has been
configured. Display the routing table of CE 2. The output shows that the route 100::/96 has been
removed.
<CE2> display ipv6 routing-table
Destinations : 4 Routes : 4
Destination: ::1/128
NextHop
Interface
Destination: 10:2::/96
NextHop
Interface
Destination: 10:2::1/128
NextHop
Interface
Destination: 200::/96
NextHop
Interface
: ::1
: InLoop0
: ::
: GE2/1/1
: ::1
: InLoop0
: ::
: NULL0
370
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Static
Preference: 60
Cost : 0