DataCard CR805 User Manual page 131

5.
Load the new roll of laminator overlay material.
a.
Put the blue supply spool on the blue supply
spindle of the cartridge (c). The overlay supply
roll can go on only one way and only fits on the
correct spindle.
b.
Put the empty silver take-up spool on the silver
take-up spindle (d).
c.
Turn the take-up spool clockwise to remove slack
from the material (e). The overlay material loads
in an S-shape.
Make sure that the overlay material is between
the guides on both the take-up and supply sides
of the cartridge.
6.
Close the laminator cartridge gate (f). Push it in
until the latch clicks in place (g). Make sure that the
overlay material is not pinched by the cartridge
gate.
7.
Replace the loaded laminator cartridge in the
printer.
8.
Remove the L2 (orange) cartridge, if installed, from
the laminator.
9.
Repeat steps 3 through 7 to load the overlay onto
the L2 cartridge.
10.
Close and lock the laminator access door.
CR805 Retransfer Card Printer User's Guide A-9