Fisher & Paykel 635 Active Smart Service Manual page 60

321144
Fault Code 29
Reason:
Primary Action:
Secondary Action:
Fault Code 40
Reason:
Primary Action:
Fault Code 41
Reason:
Primary Action:
Fault Code 42
Reason:
Primary Action:
Fault Code 43
Reason:
Primary Action:
DISPLAY FAULTS
If a fault has occurred relating to the display board, the fault code will show on the LCD display just like any
other fault.
NOTE: There will be no alarm/beeping if these faults occur.
Code
F30
F31
the icemaker solenoid current is low.
Check the connection to the solenoid. Check the resistance of the solenoid.
Correct loose connections at the module or the water valve. Replace the solenoid
if open circuit.
Icemaker solenoid transistor 1 short circuit. A transistor on the controller that
drives the icemaker solenoid has failed. This could be as a result of a fault in the
solenoid.
Check the solenoid resistance. If not within limits, replace the solenoid. Check the
wiring and connections at the solenoid and the module.
power/control module.
Icemaker solenoid transistor 2 short circuit.
Check the solenoid resistance. If not within limits, replace the solenoid. Check the
wiring and connections at the solenoid and the module.
power/control module.
Icemaker fill tube heater short circuit. (No audio alarm for this fault.)
Check the heater resistance. If not within limits, replace the heater. Refer to
Section 11.1.10 for details.
Icemaker fill tube heater open circuit. (No audio alarm for this fault.)
Check the heater resistance. If not within limits, replace the heater. Refer to
Section 11.1.10 for details.
No display signal received (shorted or broken wire).
No display signal received (shorted or broken wire) clock or data line.
Fault
60
If OK, replace the
If OK, replace the