Fisher & Paykel 635 Active Smart Service Manual page 83

• Transfer the check valve, together with the tube
from the check valve to the dispenser nozzle, to
the new door.
• Reconnect the hose at the check valve. This
valve maintains a positive pressure in the water
tank and water discharge system.
NOTE: The hose may need to be trimmed on the
end to prevent leaks.
Ensure that the hose is clipped into position
correctly.
• Refit the LCD housing, ensuring that the wiring
harness is firmly in place and is not preventing
the housing from closing.
• Refit the hinge bush and guide arm.
NOTE: The tape mark on the bottom of harness
guide arm gives the correct amount of wire length
under the hinge cover to couple to the edge
connector. The lay of the harness in relationship
to the water tube is important to prevent fatigue of
the wiring harness. The wiring harness should
have the same loop length as the water tube and
sit underneath the tube.
• Refit the hinge bracket and the wiring harness
edge connector.
• Check that the door is even and sealing correctly
all around.
• Refit the water tube and harness to the guide
assembly.
• Refit the cabinet hinge cover.
• Refit the hinge cover trim to the top of the door as
shown, applying even pressure to the clips when
re-assembling otherwise they may break.
83
321144