Fisher & Paykel 635 Active Smart Service Manual page 82

321144
• Remove the harness guide arm from the door.
NOTE: The guide arm is locked into the door hinge bush by means of a key on the arm itself. The door
hinge bush can be removed by removing the single screw that holds it to the door cap.
Key
• Withdraw the tube from the door conduit.
• Fit the harness to the bullet supplied with the
replacement door and tape the harness to the
bullet.
NOTE: This is required to pull the harness through
the conduit.
• Ease the bullet into the conduit and draw the
harness out of the door.
Once the harness is removed from the door, the door can be removed from the cabinet.
• Using the bullet as mentioned above, place the
RAST connector and hose as shown.
• Feed the harness and hose through the door
conduit.
Screw
Connector
82
Bullet
Hose