Fisher & Paykel 635 Active Smart Service Manual page 85

• Ease the bullet into the conduit and draw the
harness out of the door.
• Once the harness is removed from the door, the door can be removed from the cabinet.
• Fit the new door to the cabinet.
• From the harness RAST connector, measure 300
mm (11¾ inches) and place a mark on the
harness.
• The mark on the harness is to be placed in the
middle of the guide.
• Push the hose through the guide until the hose
equals the same length of the harness.
NOTE: By connecting the harness, it makes the
measuring easier.
• Using the bullet, place the RAST connector and
hose as shown.
Connector
85
Bullet
Hose
321144