Removing/Installing The Rim And Tire - Invacare TDX SI Service Manual

Wheelchair base

Hide thumbs Also See for TDX SI:

Parts catalog (216 pages)

User manual (104 pages)

Table Of Contents

Table of Contents

SECTION 4—WHEELS AND WHEEL LOCKS

DO NOT apply more than a 1-inch (in length) thin film of anti-seize compound to

the drive shaft. Applying more than 1-inch (in length) can cause the anti-seize

compound to leak resulting in damage to flooring (carpet, tile, etc.).

ii. Apply a thin film of anti-seize compound one inch in length to the end of the

drive shaft.

iii. Place the wheel hub onto the drive shaft.

NOTE: Align the slot in the wheel hub with the key on the drive shaft.

NOTE: While installing the wheel hub onto the drive shaft, spin the wheel hub to evenly distribute

the anti-seize compound over the entire drive shaft.

iv. Using the 1/2-20 locknut and .511/.501 x 1.290 x .12 flat washer, secure the wheel

hub to the drive shaft.

v. Secure the drive wheel to the wheel hub with the five 5/16-18 x .88-inch cap

screws. Torque to 160 in-lbs.

2. Remove the 5-inch blocks from under the wheelchair frame.

3. Install the batteries. Refer to Removing/Installing the Batteries From/Into the

Wheelchair on page 71.

4. If wheelchair is equipped with pneumatic tires, inflate tire to proper tire pressure

located on the side wall of the tire.

5/16-18 x .88-inch

Cap Screws