Mode Switch; Memory Card Slot; Preparing The Joystick For Use - Invacare TDX 5 Owner's Operator And Maintenance Manual

Mode Switch

NOTE: For this procedure, refer to FIGURE 5.4.
The mode switch is used to select the operating mode for the wheelchair. The mode
switch is located on the joystick. A mode switch is needed whenever any of the following
operating modes are programmed:
• Environmental Controls (ECU 1, ECU 2, ECU 3, ECU 4)*
• 3 Speed Mode in Digital 3 Speed (Slow, Medium, Full)
• Latched Modes
• Sleep Mode
• RIM Mode*
• Remote Drive Selection Mode*
• Tilt/Recline Mode*
• Information Center Display Selection (does not require Reset activation at power up)
If any of the above modes are selected, the control will require activation of the switch
immediately after the power switch is turned On in order to enter the drive mode. The
second line of the LCD will display - PRESS RESET.
*NOTE: In these modes, Standby Select allows the reset switch to be bypassed for users unable to
activate the switch.

Memory Card Slot

The memory card slot is used with the basic or professional memory card for saving or
reading wheelchair parameters.

Preparing the Joystick for Use

NOTE: For this procedure, refer to FIGURE 5.9.
NOTE: The joystick is factory installed on the right side of the wheelchair. To reposition the joystick
onto the left side of the wheelchair, refer to Repositioning the Joystick on page 48.
1. Turn the adjustment lock lever to
release the adjustment lock from
joystick mounting tube.
2. Slide joystick mounting tube to the
desired position.
3. Turn the adjustment lock lever to
secure the adjustment lock to the
joystick mounting tube.
Part No 1143150
SECTION 5—WHEELCHAIR OPERATION
Joystick Mounting
Tube
FIGURE 5.9 Preparing the Joystick for Use
47
NOTE: Joystick
not shown.
Adjustment
Lock Lever
TDX™ Wheelchairs