Section 9-Joystick; Preparing The Joystick For Use - Invacare P9000 XDT Owner's Operator And Maintenance Manual

SECTION 9—JOYSTICK
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the OFF position.

Preparing the Joystick for Use

NOTE: For this procedure, refer to FIGURE 9.1.
NOTE: The joystick is factory installed on the right side of the wheelchair. To reposition the joystick
onto the left side of the wheelchair, refer to Repositioning the Joystick on page 44. The joystick
should be repositioned by a qualified technician.
1. Turn the adjustment lock lever to release the joystick mounting tube from the
mounting bracket.
2. Slide joystick mounting tube to the desired position.
3. Turn the adjustment lock lever to secure the joystick mounting tube in the mounting
bracket.
Joystick Mounting Tube
Adjustment Lock Lever
Part No. 1118386
WARNING
Mounting Bracket
FIGURE 9.1 Preparing the Joystick for Use
43
SECTION 9—JOYSTICK
™
P9000 XDT