SECTION 6—SIDE FRAME
Removing/Installing the Bumpers
NOTE: For this procedure, refer to FIGURE 6.4.
NOTE: If replacing one or more bumpers, it is recommended to replace all four bumpers.
NOTE: This procedure applies to both sides of the wheelchair.
NOTE: Reverse this procedure to install the bumper.
Bolt-On Bumpers
1. Remove the drive wheel. Refer to Removing/Installing the Drive Wheel on page 35.
2. Remove the 5/16-18 keps nut and .328 x .75 x .060 washer securing the bumper to the
wheelchair frame.
3. Remove the bumper from wheelchair frame.
NOTE: If necessary repeat STEPS 1-3 on remaining bumpers.
TDX SI
TDX SI-HD
Bumper
Bumper
.328 x .75 x .060
Bumper
Washer
.328 x .75 x .060
Washer
.328 x .75 x .060
.328 x .75 x .060
Washer
Washer
5/16-18 Keps
5/16-18 Keps
Nut
Nut
FIGURE 6.4 Removing/Installing the Bumpers
55
Part No 1160845
TDX® SI/SI-HD