Removing/Installing The Fender Assembly - Invacare TDX SI Service Manual

SECTION 6—SIDE FRAME

Removing/Installing the Fender Assembly

NOTE: For this procedure, refer to FIGURE 6.3.
Removing
1. Remove the drive wheel. Refer to Removing/Installing the Drive Wheel on page 35.
2. Remove the three 10-32 x 5/8-inch hex head screws that secure the fender to the
walking beam.
3. Remove the fender from the walking beam.
Installing
1. Align the fender with the walking beam.
2. Secure the fender to the fender bracket with the three 10-32 x 5/8-inch mounting
screws. Securely tighten. Torque to 40 in-lbs.
3. Install the drive wheel. Refer to Removing/Installing the Drive Wheel on page 35.
10-32 x 5/8-inch
Hex Head Screw
FIGURE 6.3 Removing/Installing the Fender Assembly
TDX® SI/SI-HD
Walking Beam
Fender
54
Part No 1160845