Disassembling/Assembling Rear Suspension Assembly
NOTE: For this procedure, refer to FIGURE 7.3.
NOTE: Reverse this procedure to assemble the rear suspension assembly.
NOTE: If it is necessary to replace part of the rear suspension assembly, use the necessary new
parts when assembling the rear suspension assembly.
1. Remove the rear springs from the rear suspension assembly. Refer to
Removing/Installing the Rear Springs on page 57.
2. Remove the rear suspension assembly from the base frame. Refer to
Removing/Installing the Rear Suspension Assembly on page 56.
3. Separate the two rear swingarms from the pivot bar.
4. Remove the center bushing assembly from the pivot bar.
Rear Swingarm
.750 x 1.125 x .720
Nylon Spacer
FIGURE 7.3 Disassembling/Assembling Rear Suspension Assembly
Part No 1160845
SECTION 7—REAR FRAME
Rear Swingarm
Center Bushing Assembly
59
Pivot Bar
TDX® SI/SI-HD