Selecting Report Warnings; Selecting Use Of A Density Patch On The Film - Kodak DryView 8150 User Manual

Adding a Modality
Selecting Report
Warnings
Selecting Use of a Density
Patch on the Film
4-18
"Warnings" are messages from the Imager indicating a non-fatal problem in
the Imager. Like "N_Events," these can be sent to the modality if desired,
but they should not be if they can cause problems at the modality.
1. On the Advanced Defaults screen, highlight Report Warnings.
2. Use the Select button to choose Yes or No.
A "Density Patch" (also called "dPatch") is a small area of specified density
on the edge of the film that can be used by the Imager software to monitor
and control changes in density from print to print. The Density Patch is used
only on 14 x17 in. film. If the modality requires a different size film, leave
this parameter set to No.
1. On the Advanced Defaults screen, highlight Density patch.
2. Use the Select button to choose Yes or No.
If you select Yes, the Imager will print a Density Patch on the edge of
every print. If you select No, it will not.
When Density Patch is selected, the Automatic Image Quality Control (AIQC)
system in the Imager is enabled. This system monitors image quality
automatically and makes adjustments to minimize sheet-to-sheet density
variation.
7F3319 October 4, 2004