Removing Film Jams From Area 5 - Kodak DryView 8150 User Manual

Troubleshooting

Removing Film jams from Area 5

Processor
Drum
Area 5
3-16
Area 5 consists of the components between the processor drum and the film
exit tray. Jams can occur in this area between the drum and the
densitometer, or in the densitometer. See the figure below.
When a jam occurs in this area all films in the imager must be removed.
Exit Tray
Plastic Thumb Tabs
Jam Area 5
1. Open the hood.
CAUTION
:
Drum and rollers inside the processor are hot. Exercise
caution when working in the drum area.
2. Clear the jammed film from the processor area (there may be more
than one sheet). If film is jammed in the drive rollers, pull the Plastic
Thumb Tab to open the rollers and free the film.
7F3319
Densitometer
H200_0009da
October 4, 2004