Chapter 2 - Installation; Rear Panel Connectors - Apollo RoadRunner HD User Manual And Instruction Manual

Hd mobile recorder
Table of Contents

Advertisement

Chapter 2 — Installation

Rear Panel Connectors

Power Port
eSATA Port
RS485 Port
Factory Reset Switch
Once all necessary connections have been made, attach the rear panel cover to the Recorder. This will prevent
tampering by unauthorized persons.
WARNING: IT IS IMPORTANT THAT INSTALLATION BRACKETS AND CABLES DO NOT INTERFERE
WITH ANY OF THE VEHICLE'S CONTROLS AND ALSO DO NOT BLOCK THE DRIVER'S
VIEW OR REACH. FAILING TO HEED THESE WARNINGS COULD CAUSE AN ACCIDENT
CAUSING SERIOUS INJURY OR DEATH.
Power Connection – J1
CAUTION: Make sure the power supply meets the requirement (9 ~ 36VDC, 30A) during operation.
The Recorder operates on a wide range of vehicles. It accepts power inputs ranging from 9 to 36 VDC. This allows
it to operate on both 12 and 24 volt systems. The power connector has five pins.
 BATTERY: The BATTERY pin must be connected to fuses that are connected directly to the positive (+) battery
power terminal. (Refer to Chapter 3 — Operation and Configuration, System Setup for details).
 ACC: The ACC pin must be connected to a fuse that is connected to the positive (+) power terminal that is
turned on when the ignition switch is in an active or on position. When this signal turns off the recorder will
continue to record video during the ignition off timeout. (Refer to Chapter 3 — Operation and Configuration,
System Setup for details).
 HEATER (if equipped): Connect the heater power connector to the Recorder. If the temperature inside the
Recorder or the removable drive assembly is 32°F (0°C) or lower, the (optional) built-in heater will operate to
increase the temperature until the temperature reaches 44.6°F (7°C). The Recorder will then boot up. After boot-up,
the temperature sensor inside the Recorder continues monitoring the temperature to ensure the temperature
remains adequate for operation.
UPS Port
Alarm Ports
Audio In Port
Connect the power connector to the Recorder.
RoadRunner HD™ | High Definition Mobile Recorder
Video In Ports
Event Port
AUX Power Port
Network Ports
RS232 Ports
GPS/Cell/WiFi Ports
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents