Apollo RoadRunner HD User Manual And Instruction Manual page 36

User Guide and Instruction Manual
GPS
PATH: Devices menu > GPS
Select the box beside Port and select from Internal, RS232 (1~2), RS485 and LAN (1 ~ 16). If the RS232 or RS485
ports are in use for another function, they cannot be configured for GPS.
If RS232, RS485 and LAN ports are selected, select Setup... and select the correct Baud Rate, Parity, Data Bits and
Stop Bits for the connected device.
If internal is selected, install GPS antenna onto the GPS connector on the rear of the recorder.
Selecting Enable Recording toggles On and Off. When set to On, the Recorder will record the GPS information.
Selecting Use GPS Time Sync toggles On and Off. When set to On, the Recorder will synchronize the time to the
GPS satellite every hour.
If the Internal GPS is selected, GPS data can be transmitted from the recorder to another device by using the Bypass
function. Select the port for transmitting the GPS data.
Select the box beside Check GPS - Interval to define GPS loss detection time. The Recorder will log and notify
GPS loss if the GPS receiver does not receive any GPS data during the set interval.
30