Apollo RoadRunner HD User Manual And Instruction Manual page 10

User Guide and Instruction Manual
CAUTION: When the heater power supply does not meet the requirement (9A@12VDC or
4.5A@24VDC) during operation, the Recorder and heater might be damaged.
WARNING: DO NOT TOUCH THE BOTTOM OR TOP OF THE REMOVABLE DRIVE WHEN REMOVING
IT AFTER THE HEATER HAS BEEN OPERATING IN LOW TEMPERATURES. DURING
OPERATION OF THE HEATER, THE TEMPERATURE OF THE DRIVE MAY INCREASE
CAUSING INJURY.
 GND: The GND (Ground) pin should be connected directly to ground (-). Although it is possible to connect
only one of the two pins, it is recommended to use two wires to create a more stable current path.
B/U PWR Connection – J2
The B/U PWR connecter provides an input for a power loss data protection (PLDP) unit. The PLDP
is charged to 12V in normal operating conditions. In the event of a power loss, the PLDP ensures the
completion of the hard disk operation and the proper shutdown of the system. The PLDP is wired to
J2connector.
Connection DC12V
Video Connection
Connect network cameras to the Recorder using RJ-45 cable (Cat5e, or Cat6).
Network Connection
eSATA Connection – J3
An eSATA port is provided to connect external storage devices for recording video.
4
VDC Output
GND Chassis Ground
The Recorder can be networked using the 1000Mb Ethernet connector. Connect a
Cat5e cable with an RJ-45 jack to the Recorder connector (on the upper side of two
Ethernet connectors). The Recorder can be networked with a computer for remote
monitoring, searching, configuration and software upgrades.