Front Panel Controls - Apollo RoadRunner HD User Manual And Instruction Manual

WiFi/Cell/GPS Connection – J12
Each connector is provided to connect WiFi, Cell and GPS antennas. The GPS antenna
will be connected to the Recorder for working with the Recorder internal GPS module
NOTE: WiFi and Cell connections will be supported in a future release.
Factory Reset Switch
The Recorder has a Factory Reset switch to the left of the Cell 1 port on the rear panel.

This switch will only be used on the rare occasions that original factory settings should be
re-loaded.
CAUTION: When using the Factory Reset, saved settings will be lost.
To reset the unit, use a straightened paperclip:
1. Turn the Recorder off by inserting the key in the On/Off switch and rotating it clockwise to the Off position.
2. Turn it on again by rotating the key counter-clockwise to the On position.
3. While the Recorder is initializing, poke the straightened paperclip into the unlabeled hole to the left of the Cell 1 port.
4. Hold the switch until the RECORD LED on the front panel blinks.
5. Release the reset switch. All of the Recorder's settings are now at the original settings it had when it left the factory.

Front Panel Controls

Front Cover
USB Port
Power Switch
LED
RoadRunner HD™ | High Definition Mobile Recorder
Drive Assembly Network Port
7