Apollo RoadRunner HD User Manual And Instruction Manual page 22

User Guide and Instruction Manual
Selecting Auto Format toggles between On and Off. When set to On, the internal hard disk drive will be formatted
automatically when the system boots if the internal hard disk drive is not formatted or used for another Recorder.
Power Management
PATH: System menu > Power Management
Selecting Ignition off Timeout toggles On and Off. When set to On, the Recorder will delay to shut down the system
after the ignition switch is turned off. Set the delay time by using the Up and Down arrows.
Selecting Use 30 seconds Delayed Start toggles On and Off. When set to On, the Recorder will delay to start the
system for 30 seconds after the ignition switch is turned on. This works only when the accessory power is applied
while the power On/Off switch is left in the On position.
CAUTION: Use 30 seconds Delayed Start will not work if you turn on the ignition switch first and
then power On/Off switch while the power On/Off switch is the Off position.
Selecting Record Voltage & Temperature toggles On and Off. When set to On, the Recorder saves its power voltage
and temperature information on the hard disk drive every second. V indicates a power voltage and T indicates a
temperature in the saved information.
Selecting the box beside Boot Up Delay After Emergency and changing the number by using the Up and Down
arrows allows you to change the range of the battery power voltage for powering up the Recorder. When the battery
power voltage is out of the Boot Up voltage range, the Recorder will not power up.
Selecting the box beside Shutdown and changing the number by using the Up and Down arrows allows changing the
range of the battery power voltage for the emergency shutdown. When the battery power voltage is lower or higher
than the Shutdown voltage and it lasts for 10 seconds, the Recorder will automatically shut down. Refer to Turning
off the Power for details about the emergency shutdown.
The first white bars from the left and right end in the slide bar indicate the Shutdown voltages, and the second white
bars from the left and right end in the slide bar indicate the Boot Up voltages. The black bar in the slide bar indicates
the current battery power voltage. The interval between the Shutdown and Boot Up voltage bars each in the left and
right of the current battery power voltage cannot be less than 1V.
Selecting the box beside Boot Up Delay After Emergency and changing the number by using the Up and Down
arrows changes the Boot Up Delay time. The Recorder will not turn on after the emergency shutdown if the battery
power voltage does not keep the range within the Boot Up voltages. In this case, turn on the Recorder by inserting the
key in the power switch and rotating it counter-clockwise to the Off position and then rotating it clockwise to the On
position. Refer to Turning off the Power for details about the emergency shutdown.
16