Water Level Reduction; Actual Weight Display; Resetting The Weighing Equipment - Electrolux W4400H Service Manual

Weighing equipment (Optional equipment)
174
Water level reduction
To achieve optimum load volumes, the weight
of the load can be seen on the display while the
machine is being loaded. If the machine does
not have a full load, the water level will be redu-
ced according to a water-level reduction table.
The water level can never be any lower than the
safety level plus the hysteresis.
Actual weight display
The Clarus control unit automatically detects if
17
weighing equipment is connected, and the ac-
tual (current) weight is shown on the display, on
one line of the menu (normal display mode).
When the machine starts to be loaded, the
18
display switches to showing the actual weight in
large numerals (weight display mode).
Normal display mode is resumed:
• If a new program number is entered using the
numeric keys.
• If is pressed.
• Automatically after the time set via "Settings
1" under "Time for weight display".
While a wash program is running, you can switch
to weight display mode by selecting "Show
weight", see the section "Show weight" under
"Machine operation".
The weight shown on the display will always be
the net weight (achieved because the weighing
equipment has been "tared"). A slight delay is
built in to prevent the display from flickering.
Resetting the weighing equipment
If the display does not show the weight (in an
17
empty machine) as zero after a program, the
weighing equipment can be reset to zero using
the TAR key.
For a description of the functions used to set
and check the tare value, see the section head-
ed "Scale adjustments" under "Machine opera-
tion".
17
Normal mode
������������������
������������
���������������������
��������������������������
����������� �����
��� ������
Resets to zero
Menu line showing
actual weight
18
Weight display mode
��������������
�����������
�����
651
4775