Electrolux W4400H Service Manual page 118

118
HEATING RELAY ON IF NOT HEATED
TEMPERATURE INCREASE ALLOWED
LEVEL EMPTY
LEVEL OVERFILL
PAUSE TEST LEVEL
PAUSE TEST TEMPERATURE
DEFAULT TEMPERATURE HYSTERIS
TEMPERATURE STEP IN COOL-DOWN
DEFAULT LOW EXTRACT TIME
DEFAULT MEDIUM EXTRACT TIME
DEFAULT HIGH EXTRACT TIME
DEFAULT DRAIN TIME
DEFAULT DISTR. TIME
DO UNBALANCE MEASUREMENT
DRAIN OPEN DELAY
START EXTRACT TIME
1
4
7
HEATING RELAY ON IF NOT HEATED
TEMPERATURE INCREASE ALLOWED
LEVEL EMPTY
LEVEL OVERFILL
PAUSE TEST LEVEL
PAUSE TEST TEMPERATURE
DEFAULT TEMPERATURE HYSTERIS
TEMPERATURE STEP IN COOL-DOWN
DEFAULT LOW EXTRACT TIME
DEFAULT MEDIUM EXTRACT TIME
DEFAULT HIGH EXTRACT TIME
DEFAULT DRAIN TIME
DEFAULT DISTR. TIME
DO UNBALANCE MEASUREMENT
DRAIN OPEN DELAY
START EXTRACT TIME
1
4
7
Programme unit
Y
Y
90
200
0
-18 °C
4 °C
4 °C
00:00
00:00
00:00
00:00
00:00
N
0:1
00:0
Use the numeric keys to
enter the value.
2 3
5 6
If you make a mistake while
8 9
entering digits:
Press ERASE.
0
When you have finished:
Press .
Y
Y
90
200
0
-18 °C
4 °C
4 °C
00:00
00:00
00:00
00:00
00:00
N
0:1
00:0
Use the numeric keys to
enter the value.
2 3
5 6
If you make a mistake while
8 9
entering digits:
Press ERASE.
0
When you have finished:
Press .
Level empty
Here you determine the water level at which the
drum will be regarded as empty.
It is advisable to set this level so that the inner
drum will have emptied, but so that some water
remains in the outer drum.
If the water has not fallen to this level before the
drain time has ended, the message "NOT DRAI-
NED" will appear on the display.
For information on the levels used for the various
machines, see the manual "Programming, PCS
Program Control Unit".
Level for over-filled drum
Here you determine the water level at which the
drum will be regarded as over-filled.
Over-filling can occur if a water valve is faulty, or if
you have over-filled the machine manually.
For information on the levels used for the various
machines, see the manual "Programming, PCS
Program Control Unit".
Under "SETTINGS 2" (i.e. later in this section) there
are two functions which influence the way the
machine reacts to over-filling:
"DRAIN TIME WHEN OVERFILL"
(i.e. DRAIN TIME AFTER OVER-FILLING)
If you have the answer N (No) inserted for the
function "ERROR OVER-FILLED" (described
below, this page), the drain valve will open and
discharge water for the time inserted as a para-
meter under ""DRAIN TIME WHEN OVERFILL".
The level will be checked after that, and the
same sequence will be repeated until the level is
back to normal.
ERROR OVER-FILLED
If you answer Y (Yes): if the drum becomes
over-filled, the machine will stop and the error
message "MACHINE OVER-FILLED" will be
displayed.
If you answer N (No): the drain valve will open
as described above.