Error Codes - Electrolux W4400H Service Manual

Error codes
The door lock control has three LEDs that show
5
whether the door lock operates normally or
whether an error has been detected. During
normal operation, the LEDs blink when the drum
is not turning and are off when the drum rotates.
In case of an error, the three LEDs will show the
error condition according to the table below. Any
error codes are automatically cleared 5 minutes
after the error has been remedied. In case the
error occurred at the end of the programme, the
door also unlocks after 5 minutes.
LEDs
A B C
● ● ●
❍ ❍ ❍
LEDs
A B C
● ● ❍
❍ ● ●
● ❍ ❍
❍ ● ❍
● ❍ ●
❍ ❍ ●
❍ = no lit, ● = lit
Door and door lock
Normal operation
No error. The drum is not rotating
(LEDs blinking)
No error. The door is locked and there
is water in the machine (LED's blinking
double-time).
No error. The drum is rotating
Error state
Level guard B2 indicates water in
drum when the door lock is open
(input X9 not closed).
Motor control indicates that motor
is operating when door lock is open
(input X94 closed).
No signal from rotation sensor B
(frequency input X95 < 0.4 Hz) in spite
of the motor control indicating motor
operation.
No signal from motor control (input
X94 open) in spite of rotation sensor
B indicating motor operation
(frequency input X95 > 0.4 Hz).
Error in drive circuits for door lock
(output X96) or error in door lock/cable
harness for the door lock.
Internal error in the door lock control.
5
Resetbutton
15
LEDs
A
B
C
5184