Electrolux W4400H Service Manual page 122

122
TEMPERATURE STEP IN COOL-DOWN
DEFAULT LOW EXTRACT TIME
DEFAULT MEDIUM EXTRACT TIME
DEFAULT HIGH EXTRACT TIME
DEFAULT DRAIN TIME
DEFAULT DISTR. TIME
DO UNBALANCE MEASUREMENT
DRAIN OPEN DELAY
START EXTRACT TIME
ROLLOUT TIME
PAY PER WASH ALARM
LOCK TEST DELAY
DRAIN TIME WHEN OVERFILL
OIL LUBRICATION HOURS
1
4
7
DEFAULT LOW EXTRACT TIME
DEFAULT MEDIUM EXTRACT TIME
DEFAULT HIGH EXTRACT TIME
DEFAULT DRAIN TIME
DEFAULT DISTR. TIME
DO UNBALANCE MEASUREMENT
DRAIN OPEN DELAY
START EXTRACT TIME
ROLLOUT TIME
PAY PER WASH ALARM
LOCK TEST DELAY
DRAIN TIME WHEN OVERFILL
OIL LUBRICATION HOURS
PULSE TIME OIL LUBR. SEC
1
4
7
Programme unit
4 °C
00:10
00:15
00:20
00:40
00:0
Y
0:13
00:0
00:01
0
0:10
0:05
100
Use the numeric keys to
enter the value.
2 3
5 6
If you make a mistake while
8 9
entering digits:
0
Press ERASE.
When you have finished:
Press .
00:10
00:15
00:20
00:40
00:0
Y
0:1
00:30
00:01
0
0:10
0:05
100
0:01
Use the numeric keys to
enter the value.
2 3
5 6
If you make a mistake while
8 9
entering digits:
0
Press ERASE.
When you have finished:
Press .
Drain open delay
Here you determine whether you want a delay be-
fore the drain valve opens, for example if you want
the drum to have time to gather speed first, before
the valve opens.
The drain module
may be structured according to point 1 (here)
only, according to point 2 only, or a combi-
nation of 1 and 2, according to the way you
program.
1 Drain time
The drain will be open. The motor may be at a
standstill, on gentle action or normal action.
2 Distribution time
The drain will be open. The motor runs at dist-
ribution speed. During this time the wash load
will be distributed evenly around the walls of
the inner drum.
Speed
1
Drain open
Drain closed
You can program this time here
Start extract time (i.e. Initial extraction time)
Here you determine the length of time for initial
extraction (if used).
When you are programming the "main data" for
a wash program you can determine whether the
program is to begin with initial extraction. Ini-
tial extraction is used to spin the load outwards
against the drum walls, which makes it absorb
water more readily on first filling. As a result of this
the machine will not require so much extra filling
(repeated topping up) later (to maintain its required
water level).
There are two other functions affecting initial
extraction which can be programmed under SET-
TINGS 2:
• START EXTRACT SPEED
• START EXTRACT ACCELERATION
2
Time