Electrolux W4400H Service Manual page 135

TIME DELAY BEFORE DOOR OPENING
UPPER TEMPERATURE FOR ERROR
LOWER TEMPERATURE FOR ERROR
MAX ADJUST TEMPERATURE
MAXIMUM EXTRACT SPEED
DEFAULT WASH SPEED
DISTRIBUTION SPEED
DEFAULT LOW EXTRACT RPM
DEFAULT MEDIUM EXTRACT RPM
DEFAULT HIGH EXTRACT RPM
START EXTRACT SPEED
DEFAULT WASH ACCELERATION
DISTRIBUTION ACCELERATION
RETARDATION ACCELERATION
EXTRACT ACCELERATION
START EXTRACT ACCELERATION
EXTRACT RETARDATION
1
4
7
START EXTRACT SPEED
DEFAULT WASH ACCELERATION
DISTRIBUTION ACCELERATION
RETARDATION ACCELERATION
EXTRACT ACCELERATION
START EXTRACT ACCELERATION
EXTRACT RETARDATION
MAX SPEED DURING FILLING
MAX LEVEL OFFS FOR AUT. CALIB.
TIME AT DISTRIBUTION SPEED 2
NUMBER OF REDIST LOW 1 UNB.
NUMBER OF REDIST LOW 2 UNB.
NUMBER OF REDIST MEDIUM UNB.
NUMBER OF REDIST HIGH UNB.
NUMBER OF REDIST EXTREME UNB.
DRAIN TIME AT PROGR. START
DRAIN TIME AT PROGR. END
READY
1
4
7
Programme unit
0:0
98°C
-9°C
97°C
1200
48
90
550
700
900
1000
20
9
40
40
50
Use the numeric keys to
2 3
enter the value.
5 6
8 9
If you make a mistake while
entering digits:
0
Press ERASE.
When you have finished:
Press .
1000
20
9
40
40
50
100
Use the numeric keys to
2 3
enter the value.
5 6
8 9
If you make a mistake while
entering digits:
0
Press ERASE.
When you have finished:
Press .
Default value, extraction time
Here you determine the various speeds (low, me-
dium and high) for extraction. The instructions for
determining the length of extraction times are to
be found earlier in SETTINGS 2.
How an extraction sequence works:
In order to extract some of the water from the
load at lower speeds, the drum does not acce-
lerate to its highest speed immediately. Instead
it accelerates in several steps. This means that
the drum first accelerates to a low speed level,
remains at that for a certain time, then accele-
rates to a higher level, extracts at that speed for
a certain time, and so on until it reaches its final
(maximum) extraction speed. If you program a
low extraction speed, the number of steps at
the beginning of the extraction sequence may
be reduced.
Speed
high
medium
low
Start extract speed (i.e. Initial extraction
speed)
Here you determine the speed of initial extraction.
When you are creating a wash program you can
determine (under "Main data") whether it is to
begin with initial extraction. Initial extraction is
used to spin the load outwards against the drum
walls, which makes it absorb water more readily
on first filling. As a result of this the machine will
not require so much extra filling later.
There are two other functions affecting initial
extraction which can be programmed under SET-
TINGS 2:
• START EXTRACT TIME
• START EXTRACT ACCELERATION
15
Time