Electrolux W4400H Service Manual page 130

10
AMOUNT OF I/O MODULES (1-)
DELAY CLEAR DOOR TEXT
MAX DRAIN TIME
TIMEOUT DURING PAUSE
MINIMUM TEMPERATURE INCREASE
DOOR OPEN DELAY FOR MOTOR LOST 1:00
ERROR, NO WATER
ERROR, OPEN DOOR
ERROR, DOOR LOCK
ERROR, LOW TEMPERATURE
ERROR, HIGH TEMPERATURE
ERROR, WATER IN MACHINE
ERROR, NO HEAT
1
4
7
ERROR, NO WATER
ERROR, OPEN DOOR
ERROR, DOOR LOCK
ERROR, LOW TEMPERATURE
ERROR, HIGH TEMPERATURE
ERROR, WATER IN MACHINE
ERROR, NO HEAT
ERROR, REMAINING WATER
ERROR, UNBALANCE SWITCH
ERROR, MOTOR COMMUNICATION
ERROR, LEVEL ADJUST
ERROR, EMERGENCY STOP
ERROR, WEIGHT FROM SCALE
ERROR, DOOR LOCK SWITCH
ERROR, START NOT ALLOWED
ERROR, MIS COMMUNICATION
ERROR, EWD INTERLOCK
ERROR, I/O COMMUNICATION
ERROR, LOW OIL LEVEL
ERROR, LOW OR HIGH VOLTAGE
ERROR, ERROR CODES FROM MOTOR
ERROR, PRESS SENSOR TILT
ERROR, PRESSURE SENSOR TIMEOUT
ERROR, DOOR SWITCH TILT
ERROR, LEVEL OFFSET
ERROR, LEVEL SYSTEM NOT CALIB.
1
4
7
Programme unit

04:00
4:00
1:00
5°C
Y
Y
Y
Y
Y
Y
Y
Use the numeric keys to
2 3
enter the value.
5 6
If you make a mistake while
8 9
entering digits:
0
Press ERASE.
When you have finished:
Press .
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Use the numeric keys to
2 3
enter the value.
5 6
8 9
If you make a mistake while
entering digits:
0
Press ERASE.
When you have finished:
Press .
Door open delay for "motor lost"
Here you determine the length of time during
which the door will be prevented from opening
if, (in machines with frequency control) the MCU
loses control of braking at the end of extraction.
In machines with frequency-controlled motors it is
the MCU which ensures that the motor and drum
are braked smoothly after extraction speed.
If anything should go wrong at this stage so that
the MCU loses control of the braking process
(colloquially referred to as "motor lost") the MCU
will inform the PCU. If the program has reached
the final extraction sequence, the PCU will ensure
that the door cannot be opened until the time you
program here has elapsed.
Switch on/off monitoring of machine
functions/error message display
All of these options (involving monitoring of
machine functions and display of the related error
message if flagged) can be switched on or off
here.
If you answer Yes (Y):
This enables function monitoring/error message
display for this particular line.
If you answer No (N):
This disables function monitoring/error mes-
sage display for this particular line.
On the next two pages is a summary of all the
options accessible here, the errors monitored
and the error message which will be displayed for
each.