Test Run - Grizzly G0801 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1.
Clear all setup tools and loose objects away
from machine.
2.
Connect machine to power supply.
3.
Lift switch cap and push ON button under-
neath to turn machine ON (see Figure 19).
Switch Cap
Figure 19. Location of switch cap.
Model G0801/G0802 (Mfd. Since 09/15)
4. Listen for abnormal noises and watch for
unexpected actions from mill. Machine should
run smoothly and without excessive vibration
or rubbing noises.
— Strange or unusual noises or actions must
be investigated immediately. Turn machine
OFF and disconnect it from power source
before investigating or correcting potential
problems.
5. Turn machine OFF and wait for spindle to
come to a complete stop.
6.
Use spindle direction switch to change direc-
tion of spindle rotation.
7. Turn mill ON and verify that spindle is rotating
in opposite direction.
8. Turn machine OFF and wait for spindle to
stop.
Congratulations! The Test Run of the mill is
complete.
For Model G0801, continue to Spindle
Break-In and Inspections & Adjustments
procedures, beginning on Page 25.
For Model G0802, continue to the next
page to perform the Power Feed Test Run
procedure.
-23-