Grizzly G0801 Owner's Manual page 43

Downfeed Gearing
Grease Type .....................NLGI #2 or Equivalent
Grease Amount ....................................Thin Coat
Check/Add Frequency .........40 Hrs. of Operation
Tools Needed
Hex Wrench 4mm .............................................. 1
Hex Wrench 6mm .............................................. 1
External Retaining Ring Pliers .......................... 1
To lubricate quill downfeed gears:
1. DISCONNECT MACHINE FROM POWER!
2. Use quill lock to keep quill from moving dur-
ing following steps.
3. Loosen set screw that secures coarse
downfeed lever assembly to quill gear shaft,
then remove assembly from shaft (see
Figure 62).
4. Remove external retaining ring that secures
end cap (see Figure 62) to quill gear shaft,
then remove end cap.
Note: As end cap becomes loose, it will spin
slightly as the spring inside cavity unwinds—
this is normal.
Coarse Downfeed
Lever Assembly
End Cap
Set Screw
Figure 62. Coarse downfeed lever assembly and
end cap.
Model G0801/G0802 (Mfd. Since 09/15)
5. Clean away any grime from inside cavity and
on gear shaft, then use nozzle of a grease
gun to apply a small amount of lubricant
to teeth of gear shaft and quill pinion (see
Figure 63).
Qty
Figure 63. Right side of quill gear shaft exposed.
6.
Remove end cap from left side of quill gear
shaft that surrounds downfeed selector (see
Figure 64).
Figure 64. Left side of quill gear shaft exposed.
7.
Clean away any grime from inside the cav-
ity and the gear shaft, then use nozzle of a
grease gun to apply a small amount of lubri-
cant to teeth of gear shaft and fine downfeed
worm gear.
Spring
Gears
Downfeed
Selector
Gears
-41-