Power Feed (G0802) - Grizzly G0801 Owner's Manual

Power Feed (G0802)

The Model G0802 is equipped with a power feed
system for controlled X-axis table movement.
Refer to Figure 24 and the following descriptions
to understand the functions of these devices.
Table Limit Stops
Two adjustable table limit stops are located at
each end of the table (see Figure 23). They limit
automatic table movement by pressing the table
limit switch, which stops the power feed unit.
To adjust the position of the limit stops, use an
8mm hex wrench to loosen the cap screws secur-
ing the stops, reposition, and tighten securely. If
not being used, position stops at far ends of table
so as not to interfere with table movement.
Limit Stops
Limit Switch
Figure 23. Location of limit switch and limit
stops.
-28-
Operating Power Feed
1.
Loosen table locks.
2. Turn speed dial (see Figure 24) all the way
counterclockwise to slowest setting.
3.
Move direction lever to neutral (middle)
position, then move ON/OFF switch (see
Figure 24) to ON position.
4.
With your hand poised over ON/OFF switch
in case you need to suddenly turn unit OFF,
move direction lever (see Figure 24) to select
direction of table travel.
5. Use speed dial (see Figure 24) to slowly
bring speed of movement up to desired rate.
To cause table to instantly move at full speed
when already in motion, press rapid traverse
button (see Figure 24). The table will resume
previous speed when button is released.
Direction
Lever
Speed
Dial
Reset
Button
Figure 24. Power feed controls.
6. When you are finished using power feed, turn
unit OFF, rotate speed dial all the way coun-
terclockwise, and move direction lever to
neutral (middle) position to avoid unexpected
table movement later.
For additional component details, refer to
X-Axis Power Feed Controls on Page 6.
Model G0801/G0802 (Mfd. Since 09/15)
Rapid
Traverse
Button
ON/OFF
Switch