Inventory - Grizzly G0801 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Small Item Inventory (Figures 11–12)
A. Power ON/OFF Switch 220V ...................... 1
B. Toolbox ....................................................... 1
C. Bottle for Oil ............................................... 1
D. Spindle Sleeve MT#3 x MT#2 .................... 1
E. Spindle Sleeve R-8 x MT#3 ....................... 1
F.
Chuck Key .................................................. 1
G. Drill Chuck B16 1–13mm ............................ 1
H. Drill Chuck Arbor R-8/B16 .......................... 1
l. Drawbar ⁄ "-20 .......................................... 1
7
16
J. Open-End Wrenches
12/14mm & 17/19mm ............................1 Ea.
K. Hex Wrenches 3, 4, 5, 6mm .................1 Ea.
L. T-Bolts M12-1.75 x 55
w/Hex Nuts & Flat Washers ....................... 2
M. Screwdrivers Standard & Phillips #2 ....1 Ea.
N. Handwheel Handles ................................... 4
-18-
A
C
Figure 11. Large item inventory.
I
J
Qty
M
Figure 12. Small item inventory.
Model G0801/G0802 (Mfd. Since 09/15)
D
G
F
E
K
B
H
L
N