Power Feed Gears - Grizzly G0801 Owner's Manual

8. Re-install parts in reverse order they were
removed.
Note: When re-installing end cap on right side
of quill gear shaft, insert spring prong into
inside hole of end cap shown in Figure 65,
then rotate end cap approximately
clockwise to tension spring before securing it
to head.
Figure 65. End cap from the right side of quill
gear shaft.
-42-
⁄ -turn
1
3
Insert Spring
Prong Here

Power Feed Gears

Grease Type .....................NLGI #2 or Equivalent
Grease Amount ........Two Pumps of Grease Gun
Check/Add Frequency .......160 Hrs. of Operation
Tool Needed
Wrench 19mm ................................................... 1
To lubricate power feed gears:
1. DISCONNECT UNIT FROM POWER!
2. Push handwheel in to engage detent sleeve
and prevent leadscrew from rotating, then
remove cap screw, fender washer, and
handwheel from power feed end of X-axis
leadscrew (see Figure 66).
Detent
Sleeve
Figure 66. X-axis handwheel mounting
fasteners.
3.
Remove compression spring, spacer, and
detent sleeve (see Figure 67).
Figure 67. X-axis leadscrew with cap screw,
fender washer, and handwheel removed.
Model G0801/G0802 (Mfd. Since 09/15)
Qty
Cap
Screw
Fender
Washer
Compression
Spring
Detent
Spacer
Sleeve