Grizzly G0801 Owner's Manual page 48

Power Feed
Symptom Possible Cause
Power feed will not 1. Power feed unit unplugged.
turn on.
2. Limit switch engaged.
Power feed does 1. Table locked.
not move table or
2. Direction lever not engaged.
is slipping when
3. Gears not meshing or teeth missing.
turned on.
4. Motor shaft and gear shaft not engaged.
Operates at high 1. Rapid micro switch is stuck.
speed only or is
2. Wiring harness unplugged from circuit
inconsistent.
board.
Lamp
Symptom Possible Cause
Lamp will not light. 1. Power switch not turned on.
2. Bulb is burned out.
3. Short in wiring or wired incorrectly.
4. Switch at fault.
-46-
Possible Solution
1. Move on/off switch to OFF position, move direction
lever to neutral (middle) position, and rotate speed
dial all the way counter clockwise to lowest setting
to prevent accidental startup (Page 28), then plug
power feed unit into properly grounded outlet.
2. Adjust limit stops, if necessary (Page 28).
1. Disengage table locks (Page 27).
2. Engage direction lever (Page 28).
3. Check gears and adjust/replace.
4. Replace clutch.
1. Lightly tap on it to lower it.
2. Reconnect wiring harness.
Possible Solution
1. Press switch/button on lamp or control panel.
2. Replace bulb.
3. Trace and test wiring. Fix any errors.
4. Replace/repair as necessary.
Model G0801/G0802 (Mfd. Since 09/15)